Hide Table of Contents

Motion Study Properties PropertyManager

Animation

Frames per second. This value, multiplied by the length of the animation, specifies the total number of frames that are captured. This value does not affect the playback speed.

Basic Motion

Frames per second. This value, multiplied by the length of the animation, specifies the total number of frames that are captured. This value does not affect the playback speed.

Geometry Accuracy. Basic Motion makes meshes out of curved geometry. The higher the accuracy, the closer to actual geometry the mesh becomes. This makes collision simulation more accurate, but requires more time to compute.

3D Contact Resolution. Controls the allowed amount of  penetration within geometric meshes. Lower settings allow more penetration within the mesh. Using solid body Contact produces smoother motion, especially in tight-fit situations. For example, you can include solid body   Contact information before calculating the  smooth motion of a ball rolling in a channel that has very little clearance.

Motion Analysis

Frames per second. This value, multiplied by the length of the animation, specifies the total number of frames that are captured. This value does not affect the playback speed.

Animate during simulation. Clearing this option speeds up the calculation time and prevents the graphics from displaying the motion during calculation of the simulation.

Replace redundant mates with bushings. This option converts redundant mates in the assembly into bushings. In most cases, this increases the required calculation time.

Bushing Parameters. After selecting Replace redundant mates with bushings, click Bushing Parameters to change the stiffness and damping for all bushings that replace redundant mates.

Display results graphics as wireframe.

3D Contact Resolution. SolidWorks Motion typically represents shapes as many-sided polygons. The higher the number of sides, the more closely SolidWorks Motion approximates the actual geometry. However, this increases the required calculation time when you introduce solid body Contact.

Use Precise Contact. Select to calculate contact using the equations that represent the solid bodies. Clear to calculate contact approximately using the geometry of many-sided polygons. When you select Use Precise Contact, the computed contact is analytically correct, but the computation can take longer than an approximate solution.

Accuracy. Higher values increase the required calculation time.

Cycle settings. Specifies the cycle rate or period. Cycle settings defines the cycle angle used in custom Motor or Force profiles.

Cycle rate. Specifies the cycle rate in cycles per second.

Cycle time. Specifies the cycle period in seconds.



Plot Defaults. Set definitions for the plot display.

Advanced Options. Additional options for advanced users.

General Options

Use these settings as defaults for new motion studies. When you select this option before closing the Motion Study Properties PropertyManager, the settings are applied as defaults for each motion study you create.

Show all Motion Analysis solver messages. Select this option to show messages during Motion Analysis study computations.

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Motion Study Properties PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.