Hide Table of Contents

Sheet Metal Gauge/Bend Table

Sheet metal gauge/bend tables store properties for a designated material. A single table lets you associate a bend allowance, bend radius, or k-factor with any combination of thickness, bend radius, and material.
You can also use individual gauge tables and bend tables. See Sheet Metal Gauge Table and Bend Table Overview.
You can access the sheet metal gauge/bend table:
  • While creating the base flange, from the Base Flange PropertyManager.
  • After creating the base flange, by right-clicking Sheet Metal in the FeatureManager design tree and selecting Edit Feature.

Tables are included in the SolidWorks application, and are located in: <install_dir>\lang\<language>\Sheet Metal Gauge Tables\.

Both gauge/bend table and gauge tables are included. You can use them as templates to create your own tables.

The following shows a combined gauge/bend table. For each gauge number (thickness), you can select from a range of radii and angles.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sheet Metal Gauge/Bend Table
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48