Hide Table of Contents

Reassigning Hole Wizard Smart Fasteners

Copying standard Toolbox content from one folder to another does not affect smart fastener assignment. For each hole type, you can reassign smart fasteners.
Smart fastener assignment is retained when you cut Toolbox content and paste it into another Toolbox folder.

  1. Click the 1 - Hole Wizard tab.
  2. From the Hole Wizard tree, select hole type from a hole standard and category.

    For example, expand the ANSI Inch folder and the Counterbore Hole folder, and select Heavy Hex Bolt.

  3. Click Reassign and select the target fastener.
Parent topic: Hole Wizard


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Reassigning Hole Wizard Smart Fasteners
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26