Hide Table of Contents

Changing Costing Inputs

You can perform "what if" studies to see how changes, such as lot size, might affect cost, without having to actually change the model. When you change Costing inputs, you can see how the changes affect the cost immediately.

  1. In the Costing Task Pane, under Quantity, set Lot size to 50.
  2. Press Enter.

    Because Total number of parts is 100, you would need to run 2 lots to produce all of the parts. The Estimated Cost Per Part increases because you would incur 2 setup charges, one for each lot.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Changing Costing Inputs
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26