Hide Table of Contents

Thermal Joint

The new Thermal Joint helps you simulate the heat transfer from one face to another by specifying thermal resistance.

You can transfer heat from one face (or assembly of faces) to another face (or assembly of faces) without modeling the conductor itself. Specify the Heat Transfer Parameter either as the Integral Heat Transfer Coefficient (W/K), or the Thermal resistance (K/W).

Flow_wn2012_thermal_joint.gif Flow_wn2012_thermal_joint_b.gif


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Thermal Joint
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26