Hide Table of Contents

Callout Variables

You can choose a hole callout variable from the list of Hole Wizard variables. The variable is inserted in the hole callout text where the pointer is located in the Dimension Text section of the Dimension PropertyManager.

The variable name (for example, <hw-fstsze> for Fastener Size) appears in the Dimension PropertyManager. The value in the variable (5/16, for example) appears in the hole callout in the graphics area.


drw_dims_HoleCallout_Edit_Text.gif

If you select a variable from the list that is not appropriate for the hole for which you are editing the hole callout, a value of zero is displayed in the hole callout.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Callout Variables
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26