Hide Table of Contents

Examination of the FeatureManager Design Tree

A Base Flange feature creates three new features in the FeatureManager design tree:

FM_shm_sheetmetal.gif Sheet-Metal1 Contains the default bend parameters. To edit the default bend radius, bend allowance, bend deduction, or default relief type, right-click Sheet-Metal1 and select Edit Feature.
FM_shm_baseflange.gif Base-Flange1 Represents the first solid feature of the sheet metal part.
FM_sheetmtl_flatpattern.gif Flat-Pattern1 Flattens the sheet metal part. It is suppressed by default as the part is in its bent state. Unsuppress the feature to flatten the sheet metal part. When Flat-Pattern1 is:
  • suppressed, all new features are inserted above it in the FeatureManager design tree
  • unsuppressed, all new features are inserted below in the FeatureManager design tree and are not shown in the folded part


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Examination of the FeatureManager Design Tree
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48