Hide Table of Contents

Creating a Hole Series

To create a hole series:

  1. Suppress the components in your assembly that you do not want to be cut by the hole.
  2. Click Hole Series (Features toolbar) or Insert > Assembly Feature > Hole > Hole Series.

    The Hole Position PropertyManager appears.

  3. Select a location, which appears as a sketch point, on a planar face for the center of the hole series.
  4. Set the PropertyManager options for the hole series by selecting tabs.

    The tabs are always visible and you can select them in any order.

    Hole Position Create a new hole or use an existing hole.
    First Part  
    Middle Parts  
    Last Parts  
    Smart Fasteners Insert Smart Fasteners into the hole series. This tab is available only if you install and activate SolidWorks Toolbox.

  5. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Hole Series
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48