Hide Table of Contents

Editing an Explode Line Sketch

You can edit an explode line sketch to add, delete, or change explode lines.

To edit an explode line sketch:

  1. In the ConfigurationManager, click EXPAND.gif to expand ExplView CfgMgr_ExplView.gif.
  2. Right-click 3DExplode CfgMgr_Explode_Sketch.gif, and select Edit Sketch.
  3. Edit the sketch as you would for any 3D sketch, or add more explode lines.
  4. Close the sketch.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Editing an Explode Line Sketch
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26