Hide Table of Contents

Checking Static Clearances Between Components

To check clearances in an assembly:

  1. Click Clearance Verification (Assembly toolbar) or Tools > Clearance Verification.
  2. Set options and settings in the PropertyManager.
  3. Under Selected Components, click Calculate.

    The failed clearances are listed under Results. The value of each clearance appears in its listing. Under Results, you can:

    • Select a clearance to highlight it in the graphics area.
    • Expand clearances to display the names of the components.
    • Right-click a clearance and select Zoom to selection, to zoom to the clearance in the graphics area.
    • Right-click a clearance and select Ignore.
    • Right-click an ignored clearance and select Un-Ignore.

  4. Click .

    Ignored clearances are saved and the PropertyManager closes.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Checking Static Clearances Between Components
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26