Hide Table of Contents

Example of Boundary Surface Alignment

The alignment options control alignment of the boundary surface iso parameters, which control the flow of the boundary surface.

  Boundary surface feature  
  The mesh shows the iso parameters for the boundary surface feature.  
Starting surface Ending surface
  Selected curve  

Align with next section

Aligns the boundary surface iso parameters to the iso parameters of the start and end surfaces, based on distance.

Align with section normal

Aligns the boundary surface iso parameters normal to the selected curve.

Align with other geometry

Aligns the boundary surface iso parameters with greater influence determined by the end points of the selected curve.

Align with iso parameter

Aligns the boundary surface iso parameters to match the flow of the iso parameters of the starting surface at the selected curve.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Example of Boundary Surface Alignment
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26