Hide Table of Contents

Adding Weld Beads to Sheet Metal Corners

To add weld beads to a sheet metal corner:

  1. Click Welded Corner Tool_WeldedCorner_Sheet_Metal.gif (Sheet Metal toolbar) or Insert > Sheet Metal > Welded Corner.
  2. Select one of the corner faces.
    sheet_metal_welded_edge1.gif
  3. Set options in the PropertyManager.
  4. Click PM_OK.gif.
    sheet_metal_welded_edge2.gif

    Welded corners are suppressed in the flattened state.

Contents

  • Welded Corner PropertyManager

    The Welded Corner PropertyManager allows you to add a weld bead to the corners of a folded sheet metal part, including miter flanges, edge flanges, and closed corners.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Weld Beads to Sheet Metal Corners
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26