Hide Table of Contents

Creating Projection Split Lines

To create a projection split line:

  1. Click Split Line tool_Split_Line_Curves.gif (Curves toolbar) or Insert > Curve > Split Line.
  2. In the PropertyManager, under Type of Split, select Projection.
  3. Under Selections, click:
    • A sketch for Sketch to Project PM_sketch_to_project.gif. You can select multiple contours from the same sketch to split.
    • The faces to project the sketch onto for Faces to Split PM_face.gif.
    • Single direction to project the split line in only one direction.
  4. Click PM_OK.gif.

    split_line_on_surface_02.gif split_line_on_surface_04.gif
    Before After



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Projection Split Lines
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48