Hide Table of Contents

Extruding in 2D to 3D

You can extrude base features and other features using Extrude (2D to 3D toolbar) with partial sketches.

Extruded Boss/Base on the Features toolbar accepts only complete sketches.

To extrude a feature:

  1. Edit a sketch.
  2. Select the sketch entities required for the feature.

    It is not necessary to select a complete sketch.

  3. Hold Ctrl and select a point (in any sketch) to be the starting point for the extrusion.

    If you do not select a starting point, or if you select a point in the edited sketch, the plane of the sketch is considered to be the starting point.

  4. Click Extrude (2D to 3D toolbar), or click Tools > Sketch Tools > 2D to 3D > Extrude, and click in the graphics area to establish the direction of the extrusion.

    The Base-Extrude PropertyManager appears.

  5. Edit the properties in the Base Extrude PropertyManager.

    For 2D to 3D conversion, you can specify the depth of a blind extrusion by selecting a sketch entity. Click Depth and select an entity in a sketch.

  6. Click OK .
Example of Extruding in 2D to 3D Conversion

Select the sketch entities (in the Front sketch at the lower left) as the basis for the base extrusion.

Hold Ctrl and select a starting point (upper left vertex in the Top sketch).

Click in the graphics area to establish the direction of the extrusion.
In the Base-Extrude PropertyManager, click Depth and select the line shown to specify the depth of the extrusion.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Extruding in 2D to 3D
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48