Hide Table of Contents

Filtering Fittings Using the Specification Parameter

To filter fittings using the specification parameter:

  1. Start a route by dragging the fitting into an assembly.
  2. In the Route Properties PropertyManager:
    • Under Pipe (or Tube), browse to select the pipe (or tube) part.
    • Under Bends - Elbows, browse to select the elbow part. Under Parameters, select Use specification.
    • Under Parameters, select Use specification.

    For Base configuration for the pipe (or tube) and elbow, the software selects the configuration whose nominal diameter and specification value match the one you started the route with.

  3. Set other options as needed, then click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Filtering Fittings Using the Specification Parameter
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48