The Find: Boss Extrude Parameters and Find: Cut Extrude Parameters dialog boxes let you specify Find parameters for extrusions. The following parameters are available:
Direction1
|
Start Condition |
Select a start condition to find. If Offset, set an Offset value.
|
|
End Condition |
Select an end condition to find.
|
|
Depth |
Set a value for the depth of the extrude feature.
Toggle to change the comparison symbols >, <, and =.
|
|
With Draft |
Select to find extrusions by their draft angle. Set an Angle to find extruded features with drafts at a specified angle.
Toggle to change the comparison symbols, if necessary.
|
|
Merge Result (Boss extrudes only)
|
Select Any, On, or Off.
|
|
Flip Side to Cut (Cut extrudes only)
|
Select Any, On, or Off |
|
Reverse Offset and Translate Surface (For Offset From Surface as End Condition only)
|
Select Any, On, or Off |
|
Direction2 |
Select Any, On, or Off.
If you select On, set the options similar to Direction1.
|
|
Thin Feature |
Select to find thin feature extrusions.
Type
|
Select an option.
|
Thickness
|
Set a value for T1 and T2 (Two-Direction only).
|
|
For extrudes created in both directions, only one direction must satisfy the Find criteria to find the feature. For example, a boss extrude has a depth of 5mm in the first direction and 2mm in the second direction. If you Find all extrudes < 3mm, the boss extrude is found because the second direction is less than 3mm.