Hide Table of Contents

Aligning Coordinate Systems

To align coordinate systems:

  1. Open two parts to compare geometry. This example uses parts named Long.sldprt and Short.sldprt.

    The parts have different positions related to the origin. They have a coordinate system, CS1, which you can use to align them.

    Long.sldprt Short.sldprt

  2. In Long.sldprt, click Tools > Compare > Geometry.
  3. In the Compare Task Pane:
    1. Select Long.sldprt in Reference Document.
    2. Select Short.sldprt in Modified Document.
    3. Select Align parts and select CS1 as the coordinate system in Reference document and Modified document.
    4. Click Run comparison.
    5. On the Compare Geometry Results tab, click button_compare_geom_results_view.gif to display the material removed or added, or the common volume.

    The volume comparison window shows a useful comparison because of the aligned coordinate systems.

    Material removed - Results with alignment option selected Material removed - Results with alignment option cleared

  4. Click Close in the Task Pane and do not save the comparison results.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Aligning Coordinate Systems
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.