Hide Table of Contents

SelectionManager Overview

The SelectionManager combines and replaces contour and smart selection while offering enhanced selection capability

The SelectionManager is available in loft, sweep, and boundary surface features, and for path mates.

With the SelectionManager you can:

  • Select edges and sketch entities, which was not possible in smart selection.
  • Select entities across multiple sketches as well as in combination with model edges.
  • Trim and extend open selection sets at both ends, regardless of how you create them. Video: Extending a Sketch Entity with SelectionManager
  • Snap parametric trim points to geometry, so if you modify the geometry, the trim is modified.
  • Use direction manipulators to choose between different solutions that match the current selection tool. Click the manipulators to select the desired loop. In this example with the Select Closed Loop tool, you toggle between two loops and right-click to select the bottom loop. Video: Using Direction Manipulators with SelectionManager
  • Right-click to accept the selection. If there is enough information to define a solution set, the pointer changes to .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   SelectionManager Overview
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.