Hide Table of Contents

Inserting a Model View into a Drawing

To insert a model view into a drawing:

  1. Click Model View tool_Model_View_Drawing.gif (Drawing toolbar) or Insert > Drawing View > Model.
  2. Set options in the Model View PropertyManager.

    If you click Standard 3 View Tool_Standard_3_View_Drawing.gif, the PropertyManager changes to Standard 3 View, and the list of open documents is available. Select a model and click PM_OK.gif to insert a Standard 3 View.

  3. Click Next PM_next.gif.

    You can also click Standard 3 View at this point, to insert a Standard 3 View of the selected model.

  4. Set additional options in the Model View PropertyManager.

    When you place the model view, if you selected an orthogonal view orientation, the Projected View PropertyManager appears. You can place any number of projected views for any orthogonal view in the drawing.

  5. Click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Inserting a Model View into a Drawing
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26