Hide Table of Contents

Syncing Selected ProStep EDMD Changes

When syncing ProStep EDMD changes with your ECAD design system, you can select the changes to export. You can export sets of changes as an .idz file.

Before sending ProStep EDMD file information, you must enable ProStep EDMD file syncing in the CircuitWorks application.

To open a ProStep EDMD file in the CircuitWorks application, from SolidWorks, click Tools > CircuitWorks > Open ECAD File , select the file, and click Open.

To sync selected ProStep EDMD changes:

  1. On the EDMD tab, click Sync with ECAD sw_sync_tool.gif.
    The Sync with ECAD dialog box displays a summary of the messages to be sent with the ProStep EDMD data.
  2. Select messages to send:
    • To send most messages, click Change and clear the messages to withhold.
    • To send a few messages, select clear Change and select the messages to send.
  3. Click OK.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Syncing Selected ProStep EDMD Changes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48