Hide Table of Contents

Spin Box Increments Options

Sets the increments for SOLIDWORKS spin boxes.

To display this dialog box:

Click Options or Tools > Options and select Spin Box Increments.

Reset Restores factory defaults for all system options or only for options on this page.
Length increments Specifies the length added or subtracted when you click a spin box arrow to change a linear dimension value. Set the values in English units (inches) and Metric units (mm). Dimensions increment with the value and in the type corresponding to the units selected for the document. See Document Properties - Units for details.
Angle increments Specifies the degrees added or subtracted when you click a spin box arrow to change an angular dimension value.
Time increments Specifies the seconds added or subtracted when you click a spin box arrow to change a time value.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Spin Box Increments Options
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59