Hide Table of Contents

Adding a Component List Column

When you open the CircuitWorks Component Library, the component list in the left pane contains columns for the ECAD Component Name, ECAD Part Number, and Device Class. You can add columns to this list.

To add a component list column:

  1. Click Add Column .
  2. In the Mapping Column to Property dialog box, in Available properties, select a property.
    The list includes the component properties shown in the lower right pane and custom properties you have added.
    A new column labeled with the property name appears in the left pane.
You can remove columns you add, or substitute a different column that shows a different set of properties.
You cannot remove or change the original columns.
  • To remove a column, right-click the heading of an added column and click Remove Column.

    The column is removed but the properties displayed in the column are not.

  • To substitute another column:
  1. Right-click the heading of an added column and click Change Column.
  2. In the Mapping Column to Property dialog box, in Available properties, select a different property.

    The column heading and properties change to your new selection.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding a Component List Column
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48