Hide Table of Contents

Animation Techniques

You can apply the following techniques to create animated motion studies:

  • Create a basic animation by dragging the time bar and moving components.
  • Use the Animation Wizard to create animations or to add rotation, explodes, or collapses to existing motion studies (not available for a Motion Analysis study).
  • Create camera-based animations.
  • Use motors or other simulation elements to drive the motion.

You can animate the following in a motion study:

  • Component position.
  • Effects of a motor driving an assembly.
  • Effects of a Distance or Angle mate.
  • Effects of mates to single entity curves.
  • Component properties. You can hide and show components and specify the display mode (wireframe, shaded, etc.).
  • Viewpoint orientation and selection of camera views.
  • Component color or texture. Light and camera properties.
  • Position of sketch blocks.

You can create multiple animations, each with its own key frames that include key points, component positions, and view keys.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Animation Techniques
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.