|
Layer height
|
Specifies the layer height of the
striation lines. The default layer height is
0.3mm, which corresponds to a coarse printer resolution with a
relatively fast printer speed.
|
|
Show striation lines
|
Displays striation lines on the model as a texture. |
|
Show as bump map (RealView only)
|
Displays striation lines as a bump map. To view striation lines as a bump map: - RealView must be enabled in the SOLIDWORKS software.
- Show striation lines that require support must be cleared.
|
|
Thickness/Gap
Analysis |
Using Fused Deposition Modeling (FDM), calculates the
ideal wall thickness/gap based on the material and layer height. |
|
Custom thickness and
gap |
Select to specify values for thickness and
angle. |
|
FDM Material |
Specifies the FDM material. |
|
Ideal wall thickness for this
material/layer height |
Displays the calculated wall thickness based on the
FDM material and layer height. This value updates when you change
the material and layer height.
|
|
Sensitivity |
Changes the angle from 170 to 179 degrees. Move the
slider to the left side for 170 degrees and to the right side for
179 degrees. |
|
Thickness/Gap |
Specifies a thickness/gap width. Available when you select Custom
thickness and gap.
|
|
Angle |
Specifies the angle between faces. Available when you select Custom
thickness and gap.
|
|
Calculate |
Runs the thickness/gap analysis. |