Hide Table of Contents

Lightweight Drawings

Lightweight drawings are analogous to lightweight assemblies. By default, most assembly drawings are opened as lightweight, so only a subset of model data is loaded in memory. The remaining model data is loaded as needed.

Performance of drawings of large assemblies is improved significantly with lightweight drawings. Lightweight drawings are efficient because the full model data is loaded only as it is needed.

To set assembly components to lightweight or resolved:

Right-click a component and select Set to Lightweight or Set to Resolved.

When a component is lightweight, a feather appears on the part icon in the FeatureManager design tree.

To set drawing views to lightweight or resolved:

Right-click a drawing view and select Set Resolved to Lightweight or Set Lightweight to Resolved.

A feather in the FeatureManager design tree also indicates lightweight views .

Detached drawings cannot be lightweight drawings.

With lightweight drawings, you can:

  • Create all types of drawing views

  • Attach annotations to models in views

  • Dimension models in views

  • Specify edge properties

  • Select edges and vertices

  • Set drawings of sub-assemblies to lightweight or resolved

If you print a lightweight drawing when it is out of synchronization with its model, the drawing prints with a watermark:

SolidWorks Lightweight drawing - Out-of-Date Print



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Lightweight Drawings
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46