Hide Table of Contents

Changing Annotation Planes and Orientation of Dimensions

Changing Annotation Planes

You can often select the drag handles at the end of the extension lines and drop them on another edge to change the depth of the annotation plane.

Changing the Orientation

Use the shortcut menu to change the dimension orientation.

Right-click the dimension, select Change Annotation View, and select a new view from the shortcut menu.




In this example, you select Front from the shortcut menu to place the dimension on the Front annotation view.

You must be able to orient the dimension parallel to the appropriate plane.

You can also use Edit Annotation View to move annotations from different planes and orientations into a single annotation view.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Changing Annotation Planes and Orientation of Dimensions
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.