Hide Table of Contents

Creating a Flattened Route

To flatten a route:

  1. In the route subassembly, click Flatten Route (Electrical toolbar) or Routing Electrical Flatten Route.
  2. Set options in the PropertyManager.
  3. Click PM_OK.gif.

The flattened route is created as a new configuration of the 3D electrical route sub-assembly. In the FeatureManager design tree, a Flattened Route feature is added.

To toggle between the 3D and flattened route, Right-click Route or Flattened Route and select Show Configuration.

If you selected Drawing Options in the PropertyManager, the software creates a drawing file with a flattened view of the route.

Parent topic: Flattening a Route


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Flattened Route
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46