Set drawing document properties for centerlines or center marks.
To open this page, with a drawing open, click
Options
(Standard toolbar), select the Document Properties tab, and then select Centerlines/Center Marks.
Overall drafting standard
Overall drafting standard
|
Inherited from the selected Drafting Standard page settings. |
Centerlines
Centerline extension |
Specify the default centerline extension length beyond the section geometry. This value is applied the next time you rebuild the section view.
|
Selected
![](doc1292867083758.image)
|
Cleared
![](doc1292867083992.image)
|
Center marks
Size |
Specifies the length the center mark extends past the model edge and the size of the point symbol in the center. |
![](doc1292867084320.image)
|
Extended lines |
Select to display center mark extension lines. |
Centerline font |
Select to make the center mark extension lines follow the font selected for centerlines. |
Slot center marks |
Select:
- Orient to slot
- Orient to sheet
- Mark placement at slot centers or ends for straight slots:
- Mark placement at slot centers or ends for arc slots:
These settings determine how straight and curved slots are created.
|