Hide Table of Contents

Guidelines for Selecting a Failure Criterion

Failure Criterion Evaluation

Theoretical predictions for failure of lamina are compared with experiments by comparing failure envelopes (outside the envelope, lamina failure occurs) under various biaxial states of stress. A lamina is assumed to be under a state of plane stress with non-zero stress components being s 1 , s 2 and t 12 .   Directions 1 and 2 represent ply orientation direction and transverse to ply orientation direction respectively.

A schematic of failure envelope for a particular failure theory is shown, for example, Tsai-Wu failure criterion. X and S are normal and shear strengths of the lamina respectively. t and c represent tensile and compressive loadings. The open circles in the second plot show some sample experimental results for t 12 > 0. Failure envelopes for the other failure criteria (Tsai-Hill and Maximum Stress criteria) are superimposed and accuracy of predictions evaluated against experimental results for selecting the best failure criterion.

NOTE: The graph is not representative of any material system. It is shown for understanding how a failure criterion is evaluated.

For multi-directional laminates, it is difficult to evaluate which failure theory to use. Similar failure envelopes are constructed for laminates. However, for FPF (first ply failure), which the program uses, there is a wide variation between theoretical predictions and experimental observations due to several reasons.

Based on such observations some recommendations are made to help you select among the different failure theories.

In general, it is difficult to determine which theory to use due to the lack of comprehensive experimental results. Whenever possible, you should use all three failure theories and select the worst case for a relatively conservative design.

Maximum Stress Criterion

For matrix dominated failure, the maximum stress criterion is best applied to a lamina when cross-fiber stress s 2 > 0. You can check this stress for each ply using Composite Options in Stress Plot PropertyManager.

Tsai-Hill Criterion

The Tsai-Hill criterion is best applied to a lamina when strengths are equal in tension and compression. For matrix dominated failure, the Tsai-Hill criterion is best applied to a lamina when cross-fiber stress s2 < 0.

Tsai-Wu Criterion

The Tsai-Wu criterion is best applied for unequal strengths in tension and compression. For matrix dominated failure, the Tsai-Wu criterion is best applied to a lamina when cross-fiber stress s2 < 0.

Related Topic

Composite Failure Criteria

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Guidelines for Selecting a Failure Criterion
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.