Hide Table of Contents

Preparing the Model for Analysis

To prepare the model for analysis:

  • Make transparent the model geometry that encloses the cavity so you can see the flow trajectories when you view results. Turn off RealView graphics to adjust the transparency.

  • Make sure you have only one inlet and only one outlet.

  • Enclose the inlet and outlet openings with lids , which must be solid features, such as extrudes.

Related Topics

SolidWorks FloXpress Overview



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Preparing the Model for Analysis
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21