Hide Table of Contents

Abbreviations

Commands

You can abbreviate the following commands.

A ARC
C  CIRCLE
E  ERASE
F  FILLET
L  LINE
M  MOVE
O  OFFSET
Z  ZOOM

Options

You can abbreviate responses to prompts. Type enough characters to make the selection unique among the options. For example, CIRCLE prompts for 3P/2P/<Center point>; typing 3 is enough to specify 3P.

Defaults

Defaults are shown in angle brackets (<>). You can choose the default by pressing Enter, or take the default action. For example, POLYGON prompts for Number of sides <4>. Pressing Enter accepts the default of 4. CIRCLE prompts for 3P/2P/<Center point>. Specify the center point at the prompt or with the pointer; it is not necessary to press Enter.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Abbreviations
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21