Hide Table of Contents

Connectors

Enhancements for connectors include improved accuracy for the edge weld connector, support of all connectors (except bolt and elastic support) for linear dynamic studies, and creation of a bolt or pin connector on the same component.


  • The calculation of the weld sizes for the edge weld connector is more accurate due to the improvement of the bonding algorithm between shell edges and faces.
  • All connectors, except the bolt connector and the elastic support, are supported in Linear Dynamic studies.
  • You can import a frequency study with connectors to a new linear dynamic study.
  • You can create a pin or a bolt connector by selecting cylindrical faces or edges of the same component.

    connector_same_component.gif

Parent topic: Simulation


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Connectors
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21