Hide Table of Contents

Creating Lofted Bends

To create a lofted bend:
  1. Create two separate open profile sketches.
  2. Click Lofted Bend Tool_sheet_metal_Lofted_Bend.gif (Sheet Metal toolbar) or Insert > Sheet Metal > Lofted Bends.
  3. In the graphics area, select both sketches. For each profile, select the point from which you want the path of the loft to travel.

    loft_open_profiles_shm.gif

    In the PropertyManager, under Profiles PM_profiles_loft.gif, the sketch names appear.

  4. Examine the path preview. Click Move Up PM_move_up.gif or Move Down PM_move_down.gif to adjust the order of the profiles, or re-select the sketches to connect different points on the profiles.

    lofted_bend_preview01.gif

  5. Set a value for Thickness.
  6. Click Reverse Direction PM_REVERSE_DIRECTION.GIF, if necessary.
  7. Under Bend Line Control, select:
    • Number of bend lines and set a value for Setting to control coarseness of the flat pattern bend lines.
    • Maximum deviation and set a value.

    lofted_bend_applied01.gif

    tip.gif Decreasing the value of Maximum deviation increases the number of bend lines.

    example_button_w_text.gif

  8. Click PM_OK.gif.
Parent topic: Lofted Bends


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Lofted Bends
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21