The Camera PropertyManager controls the following properties of the selected camera.
To display this PropertyManager, open the DisplayManager and click View Scenes, Lights and Cameras . Right-click Camera and click Add Camera.
Available when Aimed at target is selected.
Percent distance along edge/line/curve
If you select an edge, line, or curve for the target point, type a value, move the slider, or drag the target point in the graphics area to specify the target point distance along the entity.
Distance from target
Longitude about target
Latitude about target
Camera X
Camera Y
Camera Z
Defines the camera orientation and direction.
Field of view specifies the size of the lens.
Only available with PhotoView 360 enabled. PhotoView is available with SolidWorks Professional and SolidWorks Premium. To enable PhotoView, click the Office Products tab in the CommandManager and click PhotoView 360.
Provide feedback on this topic
SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.
* Required
Thank you for your comments. We will contact you if we have questions regarding your feedback.
Sincerely,The SOLIDWORKS Documentation Team
Print Topic
Select the scope of content to print:
We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.
Web Help Content Version: SOLIDWORKS 2013 SP05 To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help. To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.