Hide Table of Contents

Changing from One Display State to Another

To change from one display state to another:

Location Procedure
ConfigurationManager In the bottom section of the ConfigurationManager, double-click an inactive display state to make it active.

Indicates the active display state.

Indicates inactive display states.
Display Pane Right-click anywhere in the Display Pane, select Activate Display State, and select a display state.
FeatureManager Right-click Show Display Pane and select a display state.
Display States toolbar Select a display state.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Changing from One Display State to Another
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23