Hide Table of Contents

Using a Triad to Rotate a Component

To rotate a component with a triad:

  1. Right-click a component and select Move with Triad.

  2. Select a ring and drag. Also:
    • To snap, right-click the selected ring and choose Snap while Dragging. Close to the ring, the snap increment is 90°. The increment decreases as the pointer moves further away from the ring.

    • To rotate in pre-set increments, right-click the selected ring and choose Rotate 90° or Rotate 180°.
    • To type specific increments, right-click the center sphere and select Show Rotate Delta XYZ Box.
  3. Click in the graphics area to turn off the triad.

    To move or align the triad:
    • Drag the center ball to drag the triad freely.
    • Alt + drag the center ball or an arm and drop it on an edge or face to align the triad with the edge or face.
    • Right-click the center ball and select Align to, Align with Component Origin, or Align with Assembly Origin.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Using a Triad to Rotate a Component
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.