Hide Table of Contents

Thickness Analysis Reports

A report generated by the Thickness Analysis utility contains the following information:
Options Used Lists the options you selected for analysis.
Summary Displays an abridged version of the Analysis Details. If a model contains a critical face, all features that share the face are classified as critical features.
Analysis Details

Thickness range

Lists four ranges of critical thickness, with the number of faces and surface area of the model that falls into each category. Each range is color coded to the Thickness scale in the PropertyManager. (The color range is also shown in the Model View(s) section of the report.) The % of analyzed area is the total area analyzed that falls into the associated Thickness range. If a face falls into more than one Thickness range, the face is classified in the more critical of ranges.

Critical features

Lists all features that violate the Target thickness. Features are listed in the order of criticality, which is directly proportional to the maximum deviation of the feature.

Mass Properties Lists the Surface Area, Volume, and Mass of the part.
Model View(s) Displays the Thickness scale and any views you selected in the Thickness Analysis: Report Options dialog box.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Thickness Analysis Reports
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59