Hide Table of Contents

Auto Sizing Toolbox Components

Some Toolbox components can adapt to the size of the geometry to which they are dragged.

To use auto-sizing Toolbox components:

  1. Drag a Toolbox component that supports auto sizing into an assembly.

    The following Toolbox components support auto sizing:
    • Bolts and screws
    • Nuts
    • Retaining rings
    • Pins
    • Washers
    • Bearings
    • O-Rings
    • Gears

  2. Select the hole where you want to place the component.



    The component resizes and an exact preview is displayed.

    Toolbox displays a message if no matching size is available.

  3. In the PropertyManager:
    1. Under Properties, adjust the values.
    2. Under Options, select Auto size to mated geometry.

      When you select Auto size to mated geometry, the component updates when you change the geometry to which the component is mated.

  4. Drag the next component that includes your adjustments and place it.



  5. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Auto Sizing Toolbox Components
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21