> SolidWorks Simulation > Submodeling > Submodeling Study for a Pressure Vessel > Viewing Results for the Submodel

Legal Notices

Welcome to SolidWorks 2013

User Interface

SolidWorks Fundamentals

Drawings and Detailing

eDrawings

SolidWorks Enterprise PDM

SolidWorks Flow Simulation

SolidWorks Simulation

Materials in Design Studies

Results

Sensors

Submodeling

Submodeling Principles

Submodeling Study for a Pressure Vessel

Creating the Submodeling Study

Meshing the Submodel and Running the Study

Viewing Results for the Submodel

Sketching

Sustainability

SolidWorks Workgroup PDM

Viewing Results for the Submodel

After running the submodeling study, you can plot results for the submodel only.

In the submodeling study, open the von Mises stress plot of the submodel.

To compare results between the submodel and the parent study, activate the Ready-Pressure study and plot the desired result quantity.

Parent topic

Submodeling Study for a Pressure Vessel

Previous topic

Meshing the Submodel and Running the Study

Search 'Viewing Results for the Submodel' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Viewing Results for the Submodel
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.