To add a slope to a pipe route:
- Open a routing assembly and click
(Routing toolbar).
- Right-click the sketch entity at the location where you want to add the slope and select Add Slope
.The Pipe Slope PropertyManager appears.
- Select the Gravity Plane.
The pipe segment must be on that plane.
- Select a Start Point.
The start point must be a fixed point that the pipe segment can use to rotate and create the slope.
- In the PropertyManager, enter the rotation angle of the Slope, expressed as a ratio.
- Click
.
The slope is added to the pipe segment.
You can edit the slope by selecting the route segment and right-clicking
Edit Slope 
. To remove the slope, right-click the segment and select
Remove Slope 
. You can also annotate slopes in drawings and BOMs.