To create a simple elbow part:
- Create a part that meets the geometry requirements for an elbow.
- Create a connection point at each end where the pipe exits the elbow. Optionally, you can include a specification parameter so you can filter elbow configurations.
- Insert a design table to create the configurations. In the header row, include these parameters:
| BendRadius@ElbowArc |
| BendAngle@ElbowArc |
| Diameter@CPoint1 |
| Diameter@CPoint2 (value must be unique for each configuration)
|
| Specification@CPoint1 (recommended) |
| Specification@CPoint2 (recommended) |
- Save the part in the Routing library specified in Routing File Locations.