Hide Table of Contents

Changing the License Type

You select the client license type during installation.

Pre-requisites:

  • To change the license type, you must have local administrative permissions to Windows.
  • For clients installed from an administrative image (via active directory deployment or a similar scripted install), you must reinstall the client using another administrative image of the specified client type.

You can change the license type by:

  • Using Control Panel > Add/Remove Programs to remove Enterprise PDM and then reinstalling.
  • Opening the Add/Remove Programs dialog box, and selecting SolidWorks Enterprise PDM > Change. In the SolidWorks Enterprise PDM Installation Wizard, select Modify.
  • Using the About SolidWorks Enterprise PDM dialog box.

To change the client license type from the About SolidWorks Enterprise PDM dialog box:

  1. Click Help > SolidWorks Enterprise PDM Administration..
  2. Use the Client type drop-down list to select a different client license type.
  3. Click OK.
  4. When instructed to restart your computer, click OK.
  5. Restart your computer.
Depending on the license type that was used when the client was installed, changing to the CAD Editor license type from the About SolidWorks Enterprise PDM dialog box might not enable the CAD Add-in. If it does not, remove Enterprise PDM as described above and select SolidWorks Enterprise PDM Editor when you reinstall.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Changing the License Type
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS PDM 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46