Hide Table of Contents

Pin/Bolt Check box

The Pin/Bolt Check box displays the safety status of all the pin and bolt connectors in the active document.

Needs attention The folder lists all connectors with a resultant load safety ratio smaller than the user-defined safety factor.
If a connector is listed in the Needs attention folder, its load capacity is at risk. Consider resizing the connector.
OK The folder lists all connectors with a resultant load safety ratio larger than the user-defined safety factor. A connector listed in the OK folder can carry safely the loads without failing.
  Details Lists the forces in all connectors. Data cells of connectors with no-pass status are red. Data cells of connectors with a pass status are green. For nonlinear studies, the forces are listed for each solution step.

Contents



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Pin/Bolt Check box
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.29