Hide Table of Contents

Using a Pressure Vessel Design Study

To use a Pressure Vessel Design study:

  1. Run the static studies that you want to combine.
  2. Right-click the model name in the Simulation study tree and select Study.
  3. In the PropertyManager, click Pressure Vessel Design then click .
  4. Right-click Setup to access the Result Combination Setup PropertyManager.

    Select the studies that you want to combine and apply a factor for each study if you select Linear Combination.

  5. Right-click the study and select Run.

    The software combines the results of the selected studies. You can view default plots or create new plots.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using a Pressure Vessel Design Study
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21