Hide Table of Contents

Meshing the Submodel and Running the Study

You refine the mesh of the solid bodies to improve the accuracy of the results for the submodel.

You apply a fine solid mesh to the submodel using the curvature-based meshing scheme which automatically creates more elements in higher-curvature areas.

  1. In the Submodel-1 study, right-click Mesh and click Create Mesh.
  2. Under Mesh Density, move the slider to Fine.
  3. Under Mesh Parameters, select Curvature based mesh.
  4. Under Options, select Run (solve) the analysis.
  5. Click PM_OK.gif.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Meshing the Submodel and Running the Study
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21