Hide Table of Contents

Rounding Sharp Edges in an Appearance

You can set an appearance to round sharp model edges when you render with PhotoView 360.

Rounding sharp edges in an appearance does not affect model geometry. To use the Round Sharp Edges option, right-click the appearance in the Display Manager and click Edit Appearance. In the PropertyManager, on the Illumination tab, select Round Sharp Edges and set a value for the radius.

The following image shows a wheel with the yellow high gloss plastic appearance applied.

yellow_wheel_no_fillets.gif

The following image shows the same wheel and appearance, with the Round Sharp Edges option enabled and the radius set to 3mm.

yellow_wheel_fillets.gif


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Rounding Sharp Edges in an Appearance
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21