Hide Table of Contents

Inserting an Aligned Section View

To create an aligned section view:

  1. Open install_dir\samples\whatsnew\drawings\sectionview2.slddrw.
  2. Click Section View tool_Section_View_Drawing.gif (Drawing toolbar) or Insert > Drawing View > Section.
  3. In the Section View PropertyManager, click Section.
  4. In Cutting Line, select Auto-start section view if not already selected.
  5. Click Aligned Cutting-line-aligned.png and move the vertex of the cutting line to the location as shown and click.
    aligned-1.png
  6. Move the initial side of the first cutting line to the location as shown and click.
    aligned-2.png
  7. Move the initial side of the second cutting line to the location as shown and click.
    aligned-3.png

    If the Section View dialog box appears, click OK.

  8. Drag the preview to the right and click to place the section view.
    aligned-final.png


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Inserting an Aligned Section View
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.56