Hide Table of Contents

Add Relations/Properties PropertyManager

You can create geometric relations between sketch entities, or between sketch entities and planes, axes, edges, or vertices.

To open the Add Relations/Properties PropertyManager:

Click Add Relations Tool_Add_Relation_Dimensions_Relations.gif (Dimensions/Relations toolbar).

Selected Entities

Displays the names of selected sketch entities. Add entities to the list by selecting them in the graphics area.

Existing Relations

PM_relations_existing.gif Relations Displays relations that exist for the selected sketch entity.
PM_information.gif Information Displays the status of the selected sketch entity (Fully Defined, Under Defined, and so on).

Add Relations

Adds relations to the selected entities from the list.


For construction Converts the entities to construction geometry.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Add Relations/Properties PropertyManager
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.