Hide Table of Contents

Autotransitioning

You can transition from sketching a line to sketching a tangent arc, and vice versa, without selecting the arc tool.

To autotransition between line and arc:

  1. Click Line Tool_Line_Sketch.gif (Sketch toolbar) or click Tools > Sketch Entities > Line and sketch a line.
  2. Click the endpoint of the line, then move the pointer away.

    The preview shows another line.

  3. Move the pointer back to the endpoint, then away again.

    The preview shows a tangent arc.

  4. Click to place the arc.
  5. Move the pointer away from the arc endpoint.

    The preview shows a line. You can draw a line or change to an arc as in Step 3.

    To toggle between line and arc without returning to the endpoint, press A.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Autotransitioning
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23