Hide Table of Contents

Example - Data Parent in a Number Control

In this example, a length is used as the data parent for a diameter being defined in a Number control.

For a hollow shaft, you are creating a control for the inside diameter. Different diameters are available depending on which length is chosen. You specify the length variable as the data parent. Four rows appear in Range Requirements, one for each length value (5, 7, 10, and 13). In each row, you type the minimum, maximum, and increment values to define the range of inside diameters available for that length.
Parent values


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Example - Data Parent in a Number Control
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.62